HARVEST H1392, Assembly Manual

Page: 44 / 66

44
2) Lift the auger and lower the auger to the main auger intake housing,(FIG 28-1) Line up the lower gear box
and the Knuckle assembly with deflector, spacer The knuckle with the deflector should slide onto the spline
shaft of the lower gear box
3) lower the swing hopper onto the ground (FIG 28-2)
4) Locate 4 spacers, hold down part # 10170
5) locate the hold down swing hopper plates
6) Place the spacers on the intake housing 2 per side, then place the hold down swing hopper
7) Plates on top of the spacers. Using 2, 3/8" x 1 1/2" flange bolts and flange nuts push the bolts into the lined
up holes
8) Tighten the plates down
9) Repeat steps 5 to 8 for the other side.
10) Now go to the swing hopper and take the swing hopper cable with the hook on it and place it onto the
transport hook on the swing hopper
11) Crank the hopper up and Slip on safety chain and lower hopper so the safety chain is tight
12) Auger is now ready for use.
FIG 28- 2
FIG 28- 1
FIG 28- 3