HARVEST H1392, Assembly Manual

Page: 43 / 66

43
FIG 26- 3
1) Locate winch retain bracket Mount winch retain bracket to winch using (3)3/8" x 3/4" carriage bolts
2) Winch upgrade bracket
3) Locate winch upgrade bracket Mount winch upgrade bracket to bracket welded on right side of intake (2)
3/8" x 1" carriage bolts, Pin winch to bracket using 3/8" x 7" pin
Winch assembly
Step 27
1) Locate the winch and handle,
FIG 27- 1
2) Place handle on the winch and tighten with a 1/2" lock nut
3) take the cable clamp that was with the winch and mount it on the inside of the winch, you may need to
spread the cable clamp to make it fit the holes
4) Locate the hopper lift cable, Go to the transport arm for the swing hopper and feed the cable through the
end pulley
5) You will see the pulley at the bottom of the swing hopper transport arm; feed the cable around the pulley
6) Now pull the cable back to the winch, feeding it under the center of the winch and pulling it back on top
feeding it through the cable clamp
7) Once through the cable clamp push it through the side hold of the winch, attach the end of the cable to the
winch, and tighten the mounting bolts, now wind up the winch
Swing tube and hopper assembly
Step 28
1) Take the swing hopper to the main auger
Looking from
tongue back
this is left
side
FIG 26- 3A