![background image](http://html1.mh-extra.com/html/harvest-tec/491bb/491bb_installation-manual_2103714008.webp)
8
4. Installation of the Spray Shield Assembly
Installation Kits 4533 (for 3 ft wide) & 4534 (for 4 ft wide) for Standard and Packer Balers
1. Locate the flat steel directly above the stuffer forks. Figure 15, Point A
2. Align the spray shield holder (001-4435NCX) to the center of the flat steel.
3. Using the shield holder (001-4435NCX) as a template clamp the holder to the baler, mark the four holes
and drill them to 7/16” diameter ( figure 15 point B).
4. Attach the shield holder (001-4435NCX) to the baler through the two center holes usin
g the two 3/8” x
1-
1/4” hex bolts, six flat washers, two lock washers, and two hex nuts.
Six
washers (three per side)
may need to go between the baler and the spray shield holder (figure 15 point C).
5. Install the spray shield (001-4435NSX) to the holder and secure by using two lynch pins. Remove
washers if necessary (Point C), but allow for a tight fit.
001-4435NSX
001-4435NCX
Figure 15
A
B
C
Summary of Contents for 491BB
Page 2: ...2 Intentionally blank...
Page 16: ...16 NOTES...
Page 17: ...17 NOTES...
Page 18: ...18 NOTES...