INSTALLATION AND REMOVAL
61-00-75
Propeller Owner’s Manual
175
Page 3-41
Rev. 1 Jun/11
(16) Remove the wires from the start lock brackets.
CAUTION
:
DO NOT PUT THE BLADE PADDLE
IN THE AREA OF THE DE-ICE BOOT
WHEN APPLYING TORQUE TO A
BLADE ASSEMBLY. PUT THE BLADE
PADDLE IN THE THICKEST AREA
OF THE BLADE, JUST OUTSIDE OF
THE DE-ICE BOOT. USE ONE BLADE
PADDLE FOR EACH BLADE.
(17) Position the propeller on the start locks.
(a) Using the blade paddles, slowly rotate the blades
simultaneously toward low pitch until the start lock
pins engage the start lock plate.
(18) If the propeller is equipped with an ice protection system
that uses components supplied by Hartzell Propeller
Inc., applicable instructions and technical information for
the components supplied by Hartzell can be found in the
following publications available on the Hartzell web site
at www.hartzellprop.com.
(a) Manual 180 (30-61-80) - Propeller Ice Protection
System Manual
(b) Manual 181 (30-60-81) - Propeller Ice Protection
Component Maintenance Manual
(c) Manual 182 (61-12-82) - Propeller Electrical De-ice
Boot Removal and Installation Manual
(d) Manual 183 (61-12-83) - Propeller Anti-icing Boot
Removal and Installation Manual
(19) Propeller ice protection system components not
supplied by Hartzell Propeller Inc. are controlled by the
applicable TC or STC holder’s Instructions for Continued
Airworthiness (ICA).
OBSOLETE PROPELLER MODELS. SEE COVER PAGE
WARNINGS AND SERVICE BULLETIN HC-SB-61-331
