Remote Control Interface
P Codes
PT/PR-150C Module Installation & Operation Manual
Harris Corporation
Issue 1, October 2000
Intraplex Products
3-3
setting of a particular switch. See the R
emote Control Communications
section of
the multiplexer manual for details on setting the multiplexer address.
Note:
When using binary numbers with a SET command, they must be preceded by the
letter “B”, as for example:
<multiplexer address>
:
<card address>
:SET:P5 = B00000001;
In addition to the P codes, it is also possible to turn service on or off for the
module by sending
SRVC = ON
or
SRVC = OFF
in the parameter field of a
SET command.
Table 3-1 lists the meaning of all the P codes for this module.
Note:
The values shown in Table 3-1are the only legal values for setting the parameters.
Setting any parameter to a value outside its specified range will produce an
unpredictable result.
Table 3-1
Remote configuration parameter codes (P Codes)
P Code
Binary Digits
Value
Description
Parameter
7 6 5 4 3 2 1 0
SRVC
Service
ON
Turn service on (enable module)
OFF
Turn service off (disable module)
P01
First time slot for
left channel
(7.5 and 15 kHz)
B 0 0 0
0
↑
0
↑
0
↑
0
↑
0
↑
Select the starting time slot using the
five least significant bits (LSBs):
1 to 24 in a T1 or variable rate
multiplexer
Selected slot = 5 bit switch code
+ 10 to 31 in a 2 MB multiplexer
B
0
↑
0
↑
0
↑
0 0 0 0 0
Not used; set to 0
P02
Second time slot
for left channel
(15 kHz only)
B 0 0 0
0
↑
0
↑
0
↑
0
↑
0
↑
Select the starting time slot using the
five least significant bits (LSBs):
1 to 24 in a T1 or variable rate
multiplexer
Selected slot = 5 bit switch code
+ 10 to 31 in a 2 MB multiplexer
B
0
↑
0
↑
0
↑
0 0 0 0 0
Not used; set to 0
