Harris NEXIO AMP NX3801HDX, Hardware Installation And User'S Manual

Page: 128 / 140

Chapter 6
Connectors, Jumper Settings, and Circuits
118
©2011 Harris Corporation. All rights reserved.
Tip For optimal results, use a soldering iron with a fine tip. To make a solder connection
from the wire to the solder cup, first flow solder on both the cable and the cup.
Next, use tweezers to locate the wire through the hole of the solder cup. Then, use
the solder iron to flow the solder and make the connection.
WARNING: Do not push the wire down too far when installing the wire
through the hole in the solder cup or you may cause a short to the cup.
3 Repeat Step 2 for each connector position.
4 Install the grounding strap to the connector so that the long tab is placed
underneath the connector (see
Figure 6-5 ).
Figure 6-5 Grounding Strap Placement