Harris NEXIO AMP NX3801HDX, Hardware Installation And User'S Manual

Page: 49 / 140

NEXIO AMP
Hardware Installation and User Guide
39
©2011 Harris Corporation. All rights reserved.
Standard Ethernet Configuration
The following sections describe the configurations for physical ports
Ethernet 1 and Ethernet 2 when used in the standard network
configuration.
If you need to enter values for Ethernet 3 or higher, enter the appropriate IP
address(es) in NEXIO
Config — LLM tab, NetDiskServer boxes (see LLM on
page 89 ).
Ethernet 1 Port Configuration (default)
The following shows the default configuration from the factory:

Configured as the NEXIO LAN communications port

Preferred port for Ethernet based automation control (G1 only)
If you are using a direct connection:
1 In NEXIO Config , click the IP Config tab (see page 82).
2 In the Role list, select NXLAN 1 for Ethernet 1.
If you are using a Media Host architecture:
1 In NEXIO Config , click the IP Config tab (see page 82).
2 In the Role list, select Not Assigned for all Ethernet connections.
3 In the Hi-Res Net Server (MIOH) area, enter the IP address for Host 1 and Host 2.
FTP with Standard Ethernet
The FTP Server can move both SD and HD content in and out of the server system.
The following rules apply for when moving content in and out of a server
mainframe via FTP:

FTP Server module must be running on the mainframe that is used to move
clips in and out of the server system.

The FTP client controlling the transfer process may run on any computer that
has connectivity to the Ethernet port bound to the FTP service.

FTP cannot use the same Ethernet port as the low resolution proxy
(PRXEncoder).

Protocol can be used via any Ethernet port. Ethernet ports 3 and 4 can be
teamed for port redundancy. Do not team Ethernet ports 3 and 4 if they are
used in servers with the low resolution proxy (PRXEncoder) application.