37
7.0
Troubleshooting
Read and comply with instructions in this manual and use the hoist properly.
Checking the sounds from the hoist in operation is a critical inspection. Note hoist sounds during operation.
If a defect is found in the hoist, stop using it immediately and check the cause of the defect.
Only Trained and competent personnel should inspect and repair the hoist.
Table 7-1 Troubleshooting Guide
Note on proper operation:
When lifting, the hoist should make clicking sounds when moving the hand wheel.
When lowering, the hoist should not make clicking sounds when moving the hand wheel.
Symptom
Cause
Remedy
Hoist will not lift
–
Slight clicking
Improper assembly of ratchet disc, disc
installed backwards, and making incorrect
contact with the pawl.
Reassemble the pawl and ratchet disc
properly. Ensure that clicking sounds are
heard before reuse.
Hoist will not lift
–
Not Clicking
Pawl not engaging ratchet disc:
Dirt or corrosion between pawl and pawl
shaft.
Clean and lubricate pawl and pawl shaft.
Pawl shaft
Pawl
Faulty pawl spring
Replace pawl spring
Loose selector pawl spring
Perform hoist maintenance.
Hoist will lift
intermittently
–
Slight or irregular
clicking
Poor pawl movement caused by faulty pawl
spring. The spring is loose or damaged.
Perform maintenance and/or repair.
Mis-assembly of pawl spring
Reassemble it properly and ensure to check
click sound of the pawl before reuse.
Summary of Contents for CF005
