Harrington CF005, Owner'S Manual

Page: 31 / 52

31

:
Make sure the pawl spring is fixed to the pawl and the snap ring is securely set
at the groove of the pawl pin.
17)
Thread friction disc [29] on the pinion [14].
18)
Wipe out any dirt on the friction disc [29], friction plates [32] and both sides of the ratchet disc [30]
and make sure that bushing [31] is properly soaked with oil. Then place the friction plate, bushing,
ratchet disc (while the pawl [27] is rotated counterclockwise), and friction plate respectively on the
friction disc. (Make sure that the pawl meshes with the ratchet disc properly.)

:
NEVER
apply oil since the brake is a “dry system”. Thoroughly wipe out any oil
and dirt on the brake. The gear of the ratchet should point at the pawl. Otherwise, the hand wheel
cannot be assembled later.
In case the bushing does not have oil inside, soak it in turbine oil for a day. Install it without wiping the
oil. Make sure that the pawl meshes with the ratchet disc properly.
Figure 6-7 Brake Assembly
19)
Remove the dirt from the hand wheel [33] and apply machine oil to the threaded part. Assemble
onto the pinion shaft [14] by turning it clockwise as far as possible.
20)
Place wheel stopper [34] on the head of the pinion [14], insert wheel stopper pin [35] and fix it with
a split pin [36].

:
NEVER forget to bend the split pin after inserting into the wheel stopper pin.
21)
Set the notch of the hand wheel to the left hand side. Insert the vertical link of the hand chain [43]
into the notch of the hand wheel [33] and reeve the hand chain by turning the hand wheel
clockwise.
NOTE: Make sure welds on hand chain are to the outside of the hand wheel.