44
GB
General instructions and regulations
• The installation of the Doran with decorative casing must be carried out by a skilled person employed by a dealer recognized by
Harrie Leenders Haardkachels.
• The casing parts are susceptible to scratching. Handle them gently.
• After the stove has been properly installed, burn some kindling wood to check the draught.
Safety recommendations
• Glass tends to break easily, and broken glass is quite sharp. Take therefore adequate safety precautions.
• For general safety, we refer to guidelines or regulations issued by a relevant official body.
Materials and tools required
Materials included
• Crosshead screwdriver
• Box-spannerset
• Hexagonal wrench set
• Set of masonry bits
• Knife
• Plumb line
• Sliding pieces
• Spirit level
• Handtruck
• Single-walled pipe and accessories
• Top plate with or without a hole
for top or rear outlet
• Right-angled bend (rear outlet only)
• 4 self-tapping screws Ø 3.5 x 9.5
(+2 spares)
1. Removing the packaging material
• Carefully remove the packaging material (without damaging
the paint). Leave plastic cover wrapped around the stove.
• Open the lower door and unscrew the stove from the pallet.
• Thereupon, push the loose bolts out of the pallet.
2. Moving the stove
• Put a cushion or blanket between the handtruck and the stove.
• Place the stove on the handtruck, its left side resting against
the handtruck. Caution: not the side of the door!
• Then move the stove to the place of installation desired.
