- 7 -
V1-02-06
Assembly instructions pivot arm awnings US701 - US702 - US715
Situation 3 – US715
Slide the wall consoles, left and right side, including the open bearings, pro-
visionally onto the fabric roller. Measure the attachment holes to be drilled
on the wall consoles(frontal or sideways). Mark these holes on the wall or the
fitting surface. Make sure these holes are in a perfect horizontal line and use
for this purpose waterhose and plumb line.
Drill the attachment holes into the wall , use a masonry drill Ø12mm. Intro-
duce the S12 wall plugs into the holes.
Now the wall consoles can be screwed onto the fitting surface, using the washers and wood screws.
Take the fabric roller (including fabric and extension pole) and slide it with the open bearings into the
wall consoles. Attach the open bearers left and right in the wall consoles (see fig.)
In the case of motor operation the motor cable has to be passed through the passage opening before
doing this. Ensure that the fabric roller is perfectly level.
Beware of the quality of the wall, the fitting surface.
If the walls are made of cellular concrete, of soft or hollow brick, the correct type of
screw must be used, e.g. coach bolts, chemical anchoring, etc.. For this, take com-
prehensive advice from your supplier of attachment materials. The company Harol
accepts no responsibility for any attachment screws that come loose.
Make sure the holes are dust-free before pushing in the
plugs
