- 5 -
V1-02-06
Assembly instructions pivot arm awnings US701 - US702 - US715
Situation 1 – US701
Measure the holes to be drilled and do this on the side consoles of the box.
Transfer these marks to the wall or the fitting surface. Make sure these holes
are perfectly in line and use for this purpose waterhose and plumb line.
Do mark, if necessary, the holes for a possible wall bracket to be fitted into
the middle of the box and meant to prevent sagging of the box in the case
of great widths. Beware: the holes of this wall bracket are to be drilled higher
than those of the side consoles! Drill the attachment holes into the wall , use a
masonry drill Ø12mm. Introduce the S12 wall plugs into the holes.
Lift up the box and position the side consoles of the box in front of the holes. Then fix the side consoles
provisionally by means of the washers and the wood screws.
In the case of motor operation the motor cable has to be passed through the passage opening before
doing this.
Use a spirit level to make sure the box position is horizontal. Pull a cord from the two outer consoles in
order to control whether the box is hanging straight. Then tighten the screws firmly.
In case a wall bracket is to be used to support the middle of the box, then screw the wall bracket to the
bottom of the box, using the extra screw included (see fig.)
Make sure the holes are dust-free before pushing in the
plugs
