- 14 -
V1-02-06
Assembly instructions pivot arm awnings US701 - US702 - US715
E.2. Setting of the end switches of the motor
E.2.1. Roll-down direction - setting of the end position down
Allow the motor to run down. Make sure it stops in time,
before reaching the final down position. The end positions of
the motor haven’t been set at the factory , so the motor won’t
stop by itself.
Both adjusting buttons have been pushed in at the factory
(push them in if this is not the case)
Now let the motor run down until it reaches the desired end
position down. Then put the switch to its neutral
Press the white button (or yellow, depending on the building-in side) so that it rises slightly.
The end position down has been set.
E.2.2. Roll-up direction - setting of the end position up
LT - Motor
Remove the cover cap of the extension pole at the side of the motor in order to be able to reach the
adjusting buttons of the motor even when the extension pole has closed the box.
Now make the motor run up. Make sure it stops in time, just after the extension pole has closed the
box.
Then put the switch to its neutral
Press the white button (or yellow, depending on the building-in side) so that it rises slightly.
The end position up has been set
Both end positions have been set.
Let the motor run out for a couple of centimeters and put the cover cap of the extension pole back.
SLT – Motor
Make the motor run up. Make sure it stops in time, about 10 – 15 cm before reaching the box.
Then put the switch to its neutral
Press the blue button so that it rises slightly.
Let the motor run down again for another 10 – 15 cm, stop it and then close the awning .
After this you can hear the motor hum for a couple of seconds and then switch itself off.
The end position up has been set.
Both end positions have been set.
In case a new setting of the end positions should be necessary, the procedure can be repeated by
simply pushing in both adjusting buttons. In doing this you delete the existing end positions and the
setting can be repeated starting from point E.2.1.
