Harmonic Drive FHA Mini Series, Manual

Page: 36 / 50

Chapter 3 Installing the FHA-C mini actuator
FHA-C mini
36
Chapter 3 Installing the FHA-C mini actuator
3-1 Receiving Inspection
Check the following when products are received.
•Inspection procedure
(1) Check the shipping container and item for any damage that may have been caused during
transportation. If the item is damaged, immediately report the damage to the dealer it was
purchased from.
(2) A label is attached on the right side of the FHA actuator. Confirm the products you ordered by
comparing with the model on the [TYPE] line of the label. If it is different, immediately contact the
dealer it was purchased from.
The model ordering code can be found in section 1-2.
(3) A model of the driver is marked on the [TYPE] line of the label. The last three digits indicate the
voltage of power supply.
200: 3-phase or single phase 200V
100: single phase 100V
24: 24VDC power
If the voltage to be supplied is different from the label voltage, contact us immediately.
Do not connect a supply voltage other than the voltage specified
on the label.
The wrong power supply voltage may damage the driver resulting physical injury and
fire.
WARNING