Page 5
DCP-555 Installation Guide
Mechanical Installation
Mechanical Installation
Rack Mounting
Be mindful of rack equipment installation� If the unit is to be rack mounted without sufficient support
under the chassis, the unit must be supported at the rear and/or sides to lessen the stress on the front
mounting flange� The necessary support can generally be bought ready-built as a rack tray, or the unit can
be mounted between other units� Damage caused by insufficient support is not covered by the warranty� To
prevent cosmetic damage to the front panel finish, use the provided protective plastic washers under the
rack-mounting screws�
Table-Top Use
For installations where the DCP-555 will sit atop a table or other surface, attach the 4 included Bumpons near
the bottom corners of the chassis to prevent the DCP-555 from sliding around�
Under-Table Mounting
Additional tools and supplies required:
• Phillips screwdriver
• Torx® T10 screwdriver (optional)
To mount the DCP-555 under a table:
1� For a cleaner look, remove the rack ears using a Torx T10 screwdriver (optional)� Note that it is
recommeneded to re-insert the screws to avoid losing them and to maintain EMI compliance�
2� Remove the two centered phillips screws on each side of the chassis and place them aside�
3� Affix the mounting brackets to each side of the chassis using the screws removed in step 2�
Insert
Screws
Insert
Screws
Install the DCP-555 under the table as shown using the 4 included 5/8" wood screws� When under-table
mounting the DCP-555, leave at least 6" of clearance on each side and in front of the device to allow for proper
ventilation�
Insert 2
Wood Screws
6” of Clearance
Insert 2
Wood Screws
Table
6” of Clearance in Front
6” of Clearance
