Harman AMX NMX-ENC-N2312, Instruction Manual

Page: 60 / 66

Appendix A: NetLinx Control
N2312/N2322 User Manual 60
TABLE 27
NetLinx Configuration Options (Cont.)
Command Description
System Number
Determines which system to connect. This setting is dependent upon the
Master Mode
selected (see above).
• If Master Mode is set to Auto , the System Number is set and the system discovers the Central Controller’s IP
address.
• If Master Mode is set to Listen , the device connects to any Central Controller.
• If Master Mode is set to URL , the IP of the Central Controller is set.
Username
Username for the Central Controller.
Password
Password for the Central Controller.
Save Save settings made on this page.
Batch Configurations Using N-Able
One of the many benefits of using N-Able control is batch configuration. This is especially useful in larger deployments. Instead of
using the individual unit web pages (discussed in the previous section), simply open N-Able and select Tools > Batch Config . See
Figure 56 .
FIG. 56
Selecting Batch Config in N-Able
The screen shown in Figure 57 displays and allows you to choose the units you would like to enable for NetLinx control. To select
multiple units, hold down the
<Ctrl>
key. Once all of the units are selected, enable the
NetLinx On
button and click the
OK
button at
the bottom of the screen.
FIG. 57
Enabling NetLinx on Multiple Units
NOTE: Items are not filtered. In other words, if you send a NetLinx command to a device that does not support it, the command is
simply ignored.