Installing and Configuring Your AV Equipment
N2312/N2322 User Manual
15
4.
Once the Decoders and displays are connected and powered up, the LocalPlay screen appears on the displays.
NOTE:
If the LocalPlay screen does not appear, refer to the chapter
for more guidance.
NOTE:
In order for the unit to receive PoE, it must be connected to a switch or other equipment that has a PoE PSE (Power Sourcing
Equipment) port. PoE does not pass through the daisy chain (P1) port.
CAUTION:
Do not run wiring that is connected to a PoE PSE port outside of the building where the PSE resides. It is for intra-building
use only.
Step 3: Connecting Encoders to the Network and Conf iguring Stream
Settings
1.
Using a Cat-5 cable, connect your N-Series Encoder’s
P0
port to a PoE-enabled switch. In non-PoE applications connect a 12V
regulated power supply (N9312) to the two-pin terminal block plug connector (labeled
+12V 2A
).
NOTE:
In order for the unit to receive PoE, it must be connected to a switch or other equipment that has a PoE PSE port.
2.
In
N-Able
, select the
Unit Management
tab and click the
Auto Discover
button (if the table has not already populated itself
with the installed units). See
FIG. 10
Unit Management Page
3.
Find your Encoder in the list. N2300 units are displayed on the following tabs:
•
Unit Management
tab — N2300 units have
N2300 Encoder/Decoder
listed in their
Type
fields.
•
Video Matrix
tab — N2300 units are found on the
N2300
sub-tab (as shown in
NOTE:
If using multiple Encoders in your set up, it is important to plug in and configure one Encoder at a time. All Encoders come pre-
configured to use stream 2300. As you add Encoders to the network, you will need to set them up to use different streams.
