Installing and Configuring Your AV Equipment
N2312/N2322 User Manual
22
KVM Configuration
The N2312 Encoders and N2322 Decoders are KVM-capable. By default, USB connections are disabled.
Basic Setup
Follow these steps for basic KVM configuration:
1.
On the N2312 Encoder, connect the USB Mini-B port to the computer to be controlled.
2.
Connect the computer’s video output to the Encoder’s
HDMI IN
port.
3.
On the N2322 Decoder, connect the
HDMI OUT
to the display.
4.
Connect a USB keyboard and mouse to the Decoder’s USB Standard-A ports (they can be plugged into either port).
NOTE:
For wireless devices, simply plug the wireless signal receivers into these ports. For keyboard and mouse combos (with a single
connection) use the keyboard port.
5.
Using N-Able, click the
Unit Management
tab.
6.
Click the
Auto Discover
button to discover your new devices (if you have not already done so).
7.
Once discovery is complete (and you see the new units listed in N-Able), click the
Video Matrix
tab.
8.
On the matrix, click the common cell for the desired Encoder/Decoder streaming combination.
9.
Click the
Take
button to make the change to your matrix. The radio button turns green to indicate the connection was
successful.
10.
Check the
KVM Enable
box on the Encoders and Decoders being used (this setting is found on the
Settings
page).
11.
On the Decoder
Settings
page, enter the KVM Encoder’s IP address (in the
KVM IP
field).
NOTE:
Multiaccess is enabled by default, you can have multiple Decoders attached to a single Encoder. Simply go to each Decoder’s
Settings page and enable KVM and input the Encoder’s IP address (or create the connection in N-Able, as described in the steps
above).
