Harman AMX NMX-DEC-N2251, Instruction Manual

Page: 31 / 66

Encoder Configuration Options
31
N2151/N2251 User Manual
Status Section
The Status section of the Settings page is shown in Figure 25 . Options are described in Table 5 .
FIG. 25
Status Section
Ping Test Test connection by specifying an IP address or URL to
ping. Click the Ping link to initiate the test.
Trial Save Click to initially save IP address changes. Once you log
in to the unit using the new address, you will be able to
confirm and accept the changes permanently.
TABLE 4
Settings Page: Network Setup Settings (Cont.)
Option Description Notes
TABLE 5
Settings Page: Status Section
Option Description Notes
HDMI Status Indicates if a video source is connected to the Encoder.
Input Resolution Indicates the video resolution of the currently
connected source.
HDMI Status Pass Thru Indicates if a display device is connected to the
Encoder.
Bandwidth
Uncompressed
This is a snapshot of the unit as properties were loaded
to the browser, not a live counter. Refresh the page to
get an updated uncompressed bandwidth.
Output bandwidth shown even if transmit is disabled.
Bandwidth Compressed This is a snapshot of the unit as properties were loaded
to the browser, not a live counter. Refresh the page to
get an updated compressed bandwidth.
Output bandwidth shown even if transmit is disabled.
Port 50001 Source IP Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
Port 50001 can only accept a single external
connection at a time
. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Port 50002 Source IP Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
Port 50002 can only accept a single external
connection at a time
. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Serial Source IP Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
Only a single external connection can be accepted on
the port. If a device is currently showing the port
occupied (by a control system or other device), then
other connections will be rejected. However,
connection attempts from the same IP will override
the current connection.
Flush buttons These buttons reset the port.
KVM IP Shows the IP address of the KVM Decoder currently
connected to this Encoder.