Installing and Configuring Your AV Equipment
15
N2151/N2251 User Manual
5.
Once the Decoders and displays are connected and powered up, the LocalPlay screen appears on the displays.
NOTE:
If the LocalPlay screen does not appear, refer to Chapter 5, Troubleshooting for more guidance.
Step 3: Connecting Encoders to the Network and Configuring Stream
Settings
1.
Using a Cat-5e or higher cable, connect your N2151 Encoder’s
P0
port to a switch (or connect SFP+ to the
P1
port).
2.
Connect the12V regulated power supply (included in shipment) to the two-pin terminal block plug connector (labeled
+12V 2A
).
3.
In
N-Able
, select the
Unit
Management
tab and click the
Auto
Discover
button (if the table has not already populated itself
with the installed units). See
.
FIG. 10
Unit Management Page
4.
Find your Encoder in the list. N2X51 units are displayed on the following tabs:
•
Unit
Management
tab — N2X51 units have
N-Series 4K Encoder/Decoder
listed in their
Type
fields.
•
Video Matrix
tab — N2X51 units are found on the
Uncompressed
4K
and
Compressed
4K
sub-tabs (as shown in
).
NOTE:
If using multiple Encoders in your set up, it is important to plug in and configure one Encoder at a time. All Encoders come pre-
configured to use stream 1. As you add Encoders to the network, you will need to set them up to use different streams.
