Introducing Your New N2600 Series Devices
N2615-WP/N2625-WP Manual
9
Wallplate Encoder and Decoder Panel Descriptions
Encoder Panel
DISPLAY Video
On (green) when USB-C is detected
USB-C port
For Video/KVM/USB 2.0 support.
HDMI VIDEO
On (green
HDMI IN
HDMI video input.
RESET button
Recessed pushbutton. Press to initiate a “warm restart” which causes the processor to reset, but not lose
power. A reset does NOT affect the current settings.
ID button
Recessed pushbutton. Press to send notification out on the network to identify the unit (the notification
causes a pop-up dialog in N-Able and N-Command). Press and hold for 30 seconds to initiate a factory
restore.
IR In port
3-pin terminal Phoenix connector. Provides infrared (IR) input only and passes signal back to the
connected Encoder/Decoder (33-60 kHz; typically, 39 kHz). IR receiver required (not included).
POWER LED
On solid (green) when operating power is supplied (via PoE or local power supply). This activity is also
shown by the
PWR
LED on the rear panel.
STATUS LED
On flashing (green) when there is software activity. This activity is also shown by the
STAT
LED on the rear
panel.
STREAM LED
On (green) when the unit is streaming video.
HDCP LED
On (Amber) when the unit detects HDCP
LINK/ACT
On (green) / Flashing (green) based on the activity of the ethernet connection to the device.
AUDIO LED
On (green) when analog audio is enabled
AUDIO IN
3.5mm connector, Provide analog audio input
Decoder Panel
AUDIO LED
On (green) when analog audio is enabled
AUDIO OUT
3.5mm connector, Provide analog audio output
HDMI VIDEO
On (green
HDMI OUT
HDMI video output
RESET button
Recessed pushbutton. Press to initiate a “warm restart” which causes the processor to reset, but not lose
power. A reset does NOT affect the current settings.
ID button
Recessed pushbutton. Press to send notification out on the network to identify the unit (the notification
causes a pop-up dialog in N-Able and N-Command). Press and hold for 30 seconds to initiate a factory
restore.
IR In port
3-pin terminal Phoenix connector. Provides infrared (IR) input only and passes signal
back to the connected Encoder/Decoder (33-60 kHz; typically, 39 kHz). IR receiver
required (not included).
POWER LED
On solid (green) when operating power is supplied (via PoE or local power supply).
This activity is also shown by the
PWR
LED on the rear panel.
STATUS LED
On flashing (green) when there is software activity. This activity is also shown by the
STAT
LED on the rear
panel.
STREAM LED
On (green) when the unit is streaming video.
HDCP LED
On (Amber) when the unit detects HDCP
LINK/ACT
On (green) / Flashing (green) based on the activity of the ethernet connection to the device.
IR OUT
3.5mm connector. Provides IR output only (33 to 60 kHz; typically, 39 kHz). An IR emitter not included.
RS232
3.5mm connector which provides a serial control interface. Full duplex communication. Available
terminal speed settings: 1200 to 115200 baud rates.
USB 2.0 Standard- A port (x2) For USB 2.0 support connect to top connector. For HID support connect to either USB port.
