Installing and Configuring Your AV Equipment
N2615-WP/N2625-WP Manual
14
4.
Once the Decoders and displays are connected and powered up, the LocalPlay screen appears on the displays.
NOTE:
If the LocalPlay screen does not appear, refer to the chapter
for more guidance.
NOTE:
In order for the unit to receive PoE, it must be connected to a switch or other equipment that has a PoE PSE (Power Sourcing
Equipment) port.
CAUTION:
Do not run wiring that is connected to a PoE PSE port outside of the building where the PSE resides. It is for intra-building
use only.
Step 3: Connecting Encoders to the Network and Configuring Stream
Settings
1.
Using a Cat-5e cable, connect your N-Series Encoder’s
P0
port to a PoE-enabled switch.
NOTE:
In order for the unit to receive PoE, it must be connected to a switch or other equipment that has a PoE PSE port.
2.
In
N-Able
, select the
Unit Management
tab and click the
Auto Discover
button (if the table has not already populated itself
with the installed units). See
FIG. 10
Unit Management Page
3.
Find your Encoder in the list. N2600 units are displayed on the following tabs:
•
Unit Management
tab — N2600 units have
N2600 Encoder/Decoder
listed in their
Type
fields.
•
Video Matrix
tab — N2600 units are found on the
N2600
NOTE:
If using multiple Encoders in your set up, it is important to plug in and configure one Encoder at a time. All Encoders come pre-
configured to use stream 2600. As you add Encoders to the network, you will need to set them up to use different streams.
