Reference Manual - JPK-1300
24
1.
Audio:
(1)
Volume: Move the slider to adjust the output audio volume of the AMP OUT and AUDIO OUT port on JPK-1300 RX. Check “Audio
Mute” to mute audio output.
(2)
Microphone/Line Gain: Move the slider to adjust the output audio volume of the MIC/LINE IN port on JPK-1300 RX.
(3)
Audio Mixing Ratio (%): Move the slider to adjust the audio mixing ratio of Microphone/Line In or HDMI/USB-C/ARC-In (Ratio
range: 0~100%).
(4)
Audio Ducking: Click to disable the audio ducking function, or set the volume of digital background sound.
(5)
HDMI ARC: Click to enable/disable the HDMI ARC function.
(6)
Audio Out Formats: Click the drop-down menu to select the audio output port.
(7)
Audio Out Mode: Click to select the audio output mode (Mono/Stereo).
(8)
Amplifier Delay Time (s): Click the up/down arrow to set the time for amplifier delay output (Time range: 0~60s).
(9)
Speaker: Click to select the speaker impedance (4 Ohms/8 Ohms).
2.
Remote Mute: Click to select the Remote Mute Action Mode.
Direct: The REMOTE MUTE 2PIN is closed, the audio will be mute.
Inverted Direct: The REMOTE MUTE 2PIN is open, the audio will be mute.
Control
1.
RS-232 Settings:
(1)
RS-232 Port: Click to enable/disable the RS-232 serial port.
(2)
RS-232 Mode: Click to select the RS-232 serial mode (Host/Client).
(3)
Power On/Off Display: Click “ON” to send the "Power On Display" RS-232 command; Click “OFF” to send the "Power Off Display"
RS-232 command.
(4)
Set Serial Port output: Click the down arrow to respectively set the Baud Rate, Parity Bits, Date Bits, Stop Bits.
(5)
Set RS-232 command:
End Flag: Click to select the ending flag after each RS-232 command (NONE/\r/\n/\r\n).
Format: Click to select the RS-232 command Format (ASCII/Hex).
Power On/Off Display command: Enter the RS-232 command to power on/off the display (supporting two commands), and click the up/ down
arrow to set the Delay time (Time range: 0~2000ms).
2.
IR Settings:
(1)
Power On/Off Display: Click “ON” to send the "Power On Display" IR command; Click “OFF” to send the "Power Off Display" IR
command.
(2)
Learn: Click to learn the IR command, then use the remote control to learn by aligning with the IR window of JPK-1300 TX.
(3)
Save: Copy the IR CCF code to the blank window, and then click "Save" to save.
