Receiver Panel Description (UA Version)
Reference Manual - JPK-1300
10
No. Name
Description
1
POWER LED
(Green)
On:
JPK-1300 RX is powered on.
Off:
JPK-1300 RX is powered off or in standby.
2
STATUS LED
(Green)
On:
JPK-1300 RX is working properly.
Blinking:
JPK-1300 RX is not working properly.
3
LINK LED
(Green)
LED indicates the connection status of the TX and RX. On:
JPK-
1300 TX and RX are linked.
Blinking:
Link error.
Off:
No link.
4
HDCP LED
(Green)
On:
Signal is being transmitted with HDCP.
Off:
Signal is being transmitted without HDCP or no signal is being transmitted.
5
MICRO USB Port
Used for Software upgrade.
6
LAN 10/100
Connect to PC for Web UI control.
7
RESET
When JPK-1300 RX is powered on, use a pointed stylus to hold down the RESET button for five
seconds, and then release it, it will reboot and restore to its factory defaults.
8
AV LINK Port
HDBaseT input port. Connect to the AV LINK port of TX with Cat 6/6A/7 cable.
9
HDMI OUT Port
HDMI signal output port. Connect to the HDMI display device (such as TV or Projector).
10
IR OUT Port
IR signal output port. Connect with IR Blaster cable.
11
USB DEVICE
Port
USB Type A port. Connect to USB devices such as electronic whiteboard, USB camera, mouse or keyboard.
12
RS-232 Port
RS-232 control port. Used to control devices with RS-232 port, such as Projector.
13
REMOTE MUTE
Port
Fire alarm trigger port. Used to mute the audio output function when there is a fire.
14
RELAY Port
RELAY control port. Used to control projection screen rise and fall.
15
AUDIO OUT Port
Linear audio output port. Connect to amplifier or other audio LINE IN input devices.
16
MIC/LINE
Selection
Switch
When selecting “MIC” with the switch, connect the MIC/LINE IN port to a dynamic microphone; When selecting
“LINE” with the switch, connect the MIC/LINE IN port to a wire-level audio source or wireless microphone.
There are two connection methods:
1.
Unbalanced connection: Connect “+” to MIC signal, and connect “
╧
” to the ground.
2.
Balanced connection: Connect “+” to the positive signal of the microphone balance, and connect “-” to
the negative signal of the microphone balance.
17
MIC/LINE IN port Connect a dynamic microphone or a wireless microphone compatible with linear audio.
18
AMP OUT Port
4pin Phoenix Connector. Connect to speakers for audio mixing output.
19
DC 24V Port
DC 24V power input port.
