Hardware Reference Manual
86
NO.
Description
Command
Example
programmed, the module performs the
following steps:
Transmits IR signals for Enter (IR code
21).
Waits for the time set with the CTOF
command to elapse.
38
CP
Command:
SEND_COMMAND <DEV>,"'CP',<code>"
Description:
Halt and clear all active or buffered IR
commands, and then send a single IR
pulse.
Variables:
Valid response:
code = IR port’s channel value 0 to 252
(253 to 255 reserved).
Command:
SEND_COMMAND IR_1,"'CP',2"
39
CTOF
Command:
SEND_COMMAND <DEV>,"'CTOF',<time>"
Description:
Set the duration of the Off time (no
signal) between IR pulses for channel and
IR function transmissions. Off time
settings are stored in non-volatile
memory.
This command sets the delay time
between pulses generated by the 'CH' or
'XCH' send commands in tenths of
seconds.
Variables:
Valid response:
time = 0 to 255. Given in 1/10th of a
second increments. Default is 5 (0.5
seconds).
Command:
SEND_COMMAND IR_1,"'CTOF',10"
40
CTON
Command:
SEND_COMMAND
<DEV>,"'CTON',<time>"
Description:
Set the total time of IR pulses transmitted
and is stored in nonvolatile memory.
This command sets the pulse length for
each pulse generated by the 'CH' or 'XCH'
send commands in tenths of seconds.
Variables:
This command sets the pulse length for
each pulse generated by the 'CH' (see
previous page) or 'XCH' (see next page)
Send Commands in tenth of a second
increments.
Valid response:
time = 0 to 255. Given in 1/10th of a
second increments. Default is 5 (0.5
seconds).
Command:
SEND_COMMAND IR_1,"'CTON',20"
Summary of Contents for AMX DXLINK DX-RX-4K60
Page 42: ...Hardware Reference Manual 38 ...
