Hardware Reference Manual
116
NO.
Description
Command
Example
12
PERSISTAV
Command:
SEND_COMMAND <DEV>,"'PERSISTAV'"
Return:
PERSISTAV
Description:
Used to save the Receiver’s Power On
Scaler settings/mode to the DGX DXLink
Output Boards for DGX Configuration
Software.
Not required to save A/V settings to the
receiver. These are automatically
saved when changes are made.
Command:
SEND_COMMAND
dvRX,"'PERSISTAV'"
Return:
PERSISTAV
13
FACTORYAV
Command:
SEND_COMMAND <DEV>,"'FACTORYAV'"
Return:
FACTORYAV
Description:
Clear the persisted settings for the Scaler
mode, resolution, aspect ratio policy, and
audio output type and restores them to
their factory defaults.
The “Power-On” Scaler mode on an Enova
DGX DXLink Output Board will not get reset
to default (AUTO), but will remain as
whatever was last persisted.
Command:
SEND_COMMAND
dvRX,"'FACTORYAV'"
Return:
FACTORYAV
Description:
NOTE:
A reboot is required after
sending the FACTORYAV command.
14
SET TELNET PORT 0
Command:
SEND_COMMAND <DEV>,"'SET TELNET
PORT 0'"
Return:
SET TELNET PORT 0
Description:
Set the Telnet port to “0” (disabled state).
NOTE:
A reboot is required after sending
the SET TELNET PORT 0 command.
Command:
SEND_COMMAND dvRX,"'SET
TELNET PORT 0'"
Return:
SET TELNET PORT 0
15
SET TELNET PORT 23
Command:
SEND_COMMAND <DEV>,"'SET TELNET
PORT 23'"
Return:
SET TELNET PORT 23
Description:
Set the Telnet port to “23” (default port).
NOTE:
A reboot is required after sending
the SET TELNET PORT 23 command.
Command:
SEND_COMMAND dvRX,"'SET
TELNET PORT 23'"
Return:
SET TELNET PORT 23
16
?USBMODE
Command:
SEND_COMMAND <DEV>,"'?USBMODE'"
Return:
USBMODE-<HOST|DEVICE>
Description:
Get the USB Device or Host mode state for
USB pass-through direction
Command:
SEND_COMMAND
dvRX,"'?USBMODE'"
Return:
USBMODE-HOST
Description:
USB MODE is HOST
Summary of Contents for AMX DXLINK DX-RX-4K60
Page 42: ...Hardware Reference Manual 38 ...
