Hardware Reference Manual
17
Scenarios / DIP Switch Settings Table
The table below contains the most common scenarios for setting up Transmitter and Receiver as a standalone pair
or with other equipment. Find the scenario in the table that you want to use and then set the Dip switches accordingly.
A detailed explanation of functions for each toggle is provided above and on the previous page.
Common Scenarios
DIP Switch Toggle Settings
Standalone Setup-TX/RX pair direct connection
1
2
3
4
AV signals only (plus serial/IR passthrough)
OFF
OFF
OFF
OFF
AV with Ethernet passthrough to networked device* (plus serial/IR
passthrough)
ON
OFF
OFF
OFF
AV with NetLinx control of TX/RX unit and serial/IR ports**
ON
ON
ON
OFF
AV with NetLinx control of TX/RX unit and serial/IR ports, plus Ethernet
passthrough to networked device*
ON
ON
ON
OFF
Switcher setup-TX/RX with ENOVA DGX/Soiecis 4K Switcher
1
2
3
4
AV signals only
OFF
OFF
OFF
OFF
AV with Ethernet passthrough to networked device*
ON
OFF
OFF
OFF
AV with NetLinx control of TX/RX unit and serial/IR ports
OFF
OFF
ON
OFF
AV with NetLinx control of TX/RX unit and serial/IR ports, plus Ethernet
passthrough to networked device*
ON
ON
ON
OFF
* Connect the ICS LAN 10/100 port of the DXLink unit to the network device (e.g., laptop, IP controlled projector,
AMX ICSLan EXB Device). In a standalone setup, connect the ICS LAN 10/100 port of the other DXLink unit to the
network.
** In a standalone setup using NetLinx control of the DXLink serial/IR ports, only one of the DXLink units should be
connected to the network (the unit with #1 Toggle enabled).
Summary of Contents for AMX DXLINK DX-RX-4K60
Page 42: ...Hardware Reference Manual 38 ...