1 -9 0 -0 9 7 3 0 R 2 6 _ 0 6 /1 3
The Advance pellet stove is more than ust automatic ignition, it is also automatic temperature control.
The automatic system will allow the fire size to be ad usted to match the heating needs and even
put the fire out if necessary. If heat is needed after the fire is out, the Advance will automatically re-
ignite and ad ust the fire size to match the heating need. The totally automatic room sensor mode is
recommended because of its efficiency.
The unit can be switched between AUTO and ANUAL at any time during operation.
Automatic Ignition/ Operation
Room Temperature Mode:
This setting will produce a room
temperature of 70 degrees with the distribution blower at medium
speed.
This setting will produce medium heat with the distribution
blower on "low".
This setting will produce continuous maximum heat output with
the distribution blower at full speed.
Stove Temperature Mode
R oom Temperature Mode
Igniter switch to " AUTO"
In Room Temp ode heat output is controlled automatically
by the Room Sensing Probe. When the Room Sensing Probe
calls for heat, the stove will increase output. When the Room
Sensing Probe is getting close to the set temperature, the
stove will begin to level off output and keep the fire burning
at ust the right temperature to maintain that setting.
High output is determined by the feed rate setting. This
setting, generally on # , can be increased if higher burn
rates are necessary. The unit s maximum burn rate should
not create less than 1 of ash on the burn pot front edge.
See ig.2, Page 5. Overfeeding is not a safety concern, but
fuel may be wasted if unburned pellets fall into the ash pan.
In Room Temp ode a constant fuel consumption rate is
sacrificed for exact room temperature. Therefore, as it gets
colder more pellets will be burned automatically.
The distribution blower speed will vary according to the
position of the mode selector pointer, and fire size.
Stove Temperature Mode
Igniter switch to " AUTO"
This allows for automatic ignition upon start-up only. The
unit can then be set at any desired setting. The heat output
and fuel consumption will remain constant regardless of
room temperature. The unit s maximum feed rate should not
create less than 1 of ash on the burn pot front edge. See
ig 2, Page 5.
The unit s low burn or maintenance setting is as low as it will
go. It will not go out unless it runs out of fuel or is turned off.
To kill the fire or stop burning the stove, turn the ode Selector
to O
. This will cause the fire to diminish and burn out. When
the fire burns out and the stove cools down everything will stop.
If you pull the plug to shut down the stove, all motors will stop.
This may cause incomplete combustion and smoke in the firebox.
If the load door is opened the smoke may escape.
The best way to shut down the stove is simply let it run out of
pellets, then the stove will shut down automatically.
Shut-down procedure
