10
1 -9 0 -0 9 7 3 0 R 2 6 _ 0 6 /1 3
R emoving Side Doors
F ig. 1 0
Side Door Magnets
R emoving Side Doors for Installation
F igure 9
Use hand hole to swing open side doors to at least 0
o
.
F igure 1 0
Remove side doors by lifting upward on the door until the
bottom pin is out of its hole. ove the bottom of the door out
and away from the pedestal base about 1 2 . Allow the door
to slide downward until the top door pin is out of its top hole.
NOTE: Always remove the side doors and rear shields to
move the unit. This will keep them from getting damaged.
R emoving the R ear Motor Shield Sheet Metal.
NOTE:
isconnect power to the unit before removing the
motor shields. anger of electrical shock. Hot and moving
parts could cause in ury.
F igure 1 1
There are (2) #10 hex head screws holding each rear shield.
Using a 5 1 nut driver or socket, loosen the (2) screws
about or 5 turns.
F igure 1 2
Slide the rear shields straight outward until the ends come
out of the rear retaining clips, as seen in ig.1 .
There are two bolts holding the stove to the pallet (see ig.
11) Remove the bolts to move the stove.
1. When replacing the shields, always insert the top and
bottom ends of the sheet metal into the retaining clips first.
2. Slide the shields straight inward until the (2) hex head
screws are fully inserted into the stove slots.
. ake sure the top edges of the shield are against the
hopper bottom and tighten screws.
The rear shields are split around the flue tail pipe and outside
air knockout. This allows removal and installation of the rear
shields with the unit completely installed.
Placing R ear Shields Back on Unit
F ig. 9
Side Door
F ig. 1 1
Pallet Hold own Bolts
#10 hex head screws
Rear Shield Retaining clip
Outside Air nockout
F ig.1 3
Side Door
Hand Hole
F ig.1 2
