2 3
1 -9 0 -0 9 7 3 0 R 2 6 _ 0 6 /1 3
1. Scrape the top holed surface and sides of the burn pot. ig.
5. It is not necessary to completely remove all material
from the burn pot. The excess will be pushed out during
the next use.
2. Loosen the (2) wing thumb screws on the lower front angle
of the burn pot. ig.
. Lift off the clean-out cover to open the bottom clean-out
chamber. ig. 7
. Clean ash buildup from inside the chamber while cover
is off. Use the scraper to tap on the top front edge of the
burn pot. This will help knock pieces of ash, loosened
by the scraping process, down through the holes. It also
helps knock scale off of the igniter element.
The igniter is made to be removable for service by insulated
male female wire connectors. These connections between
the hot leads (the wires inside the burn pot) and the cold leads
(the wires from the control board) are always pulled to the
rear of the feeder body.
(Not coiled inside the burn pot.)
It is very important that these connections are to the inside
rear of the feeder body. Also, the extra wire of the igniter wire
service loop must be pulled out through the rear of the feeder
and tied up so that it will not be damaged by any moving
parts. See page 27.
ig. 5
Note: The hot lead/ cold lead connection must always be
pulled to the rear of the feeder body before operation.
Maintenance - Burn Pot
DANGER
Disconnect the power to the unit before removing
cover.
Burn Pot Cleaning and Maintenance
DANGER
Disconnect the power to the unit before removing
cover.
WARNING
Use caution when cleaning burn pot clean-out chamber.
Do not damage the high temperature igniter wires.
ig. 7
Viewed from below, through the ash pan opening.
Igniter hot lead wires
(High temperature)
Burn pot igniter
ig.
Wing Thumb Screws
