Harken Tensioner CT0, User And Maintenance Manual

Page: 14 / 36

Rev.0 – 19/03/2021
14
8.5 Tensioner Mounting Template
To operate the installation, follow the steps below (alphabetic indexes):
A. Place the drilling cut-out template over the point chosen for installation.
The template in DWG format and 1:1 scaled is available on request from the Harken Italy
Tech Service at
techservice@harken.it .
Small-scaled mounting template for Tensioner CT0 is shown below.
B. Mark the position of the holes to be drilled in the deck.
C. Drill the holes.
D. Seal the external part of the main holes and all the fixing holes with a suitable marine
adhesive sealant as shown in the following image (green lines).
To apply the adhesive sealant: clean and remove all grease from the bottom surface and
apply the sealant.