User and maintenance manual Winch 1111 HL
–
Mod.A
E.
Disassemble the winch until fig. # of the ‘Maintenance’ chapter of this manual.
F.
Position the base of the winch on the deck and bolt it in place using through M10 screws
of a suitable length for the thickness of the deck.
NOTE!
Harken
®
does not supply the screws needed to install the winch since these may
vary depending on the deck on which it is to be installed.
It is the installer's responsibility to choose the correct screws taking account of the
loads they will have to bear.
Harken
®
assumes no responsibility for incorrect installation of its winches or for an
incorrect choice of mounting screws.
WARNING!
Fix the winch to the deck using screws in A4-70 stainless steel.
G.
Remove excess marine sealant.
H.
Reassemble the winch following the various steps of the disassembly procedure in
reverse order.
For the disassembly procedure, refer to the ‘Disassembly procedure’ chapter of this manual.
WARNING!
The mounting bolts must be isolated with anti-corrosive lubricants.
It is mandatory to prevent any direct contact between the aluminum captive frame
from other conductive materials such as carbon fiber (deck or hull); in that case a
fiberglass lamination is required to avoid any galvanic corrosion.
