Access the user interface using the current IP address of the eCB1.
„(http://
<IP>
/)“
To do this, call up the router´s user interface and read the IP address of the eCB1 (see
manual of your router).
If you have Windows XP/7/8: install Apple Bonjour® . You can find the donwload link on
www.apple.com. Then enter the URL again.
Note:
Apple Bonjour® is also included in Apple iTunes®.
Alternatively contact the network administrator.
2. The status LED does not glow
If the
status LED
of the eCB1 does not glow, it means that
the smartmeter is not provided with any power.
Please make sure that at least one of the phase conductos
L1 and the neutral conductor N are connected to the eCB1.
3. The status LED glows or blinks red
If the
status LED
glows or blinks red, an error has occured.
Please restart the eCB1 by pressing the
reset button
with a pointy objet
for about 1 to 3
seconds.
4. The Network-LED does not glow
If the
network-LED
does not glow, the network cable is not properly/correctly connected to
the network port. Please make sure that you have inserted both ends of the cable properly
and correctly.
5. eCB1 could not be found in the network
In this case the eCB1 is not located in the same local network. Please connect the
eCB1 with the same Router/Switch as the one of your PC’s/laptop’s.
If that does not solve your problem, please reset the eCB1 to its factory settings by
pressing the
reset button
with a pointy object
for about 4 to 10 seconds.
Configuration instructions
eCB1
smartmeter
Version: 1.2.3
6
