Choose the maximum value of your house connection.
If your house connection exceeds 63 A, the installation of a transducer is obligatory.
Please contact professtional staff for further information regarding the transducer
2 ) Scaling max.- value power PV-Chart 22 kW
Settings here only impact the diagram on the first page.
Choose the value according to the maximum charging capacity of your electric vehicle.
Set the value by dragging the controller to the left or to the right.
The effects of this adjustment are visible on the surface “control”.
3) Eco-min-max-ampere 6-32 ampere
These settings depend on your electrical vehicle. There are vehicles that require minimum
charging power of 8 or 10 A (or higher).
Should the
ECO-Charging Mode
be activated and the surplus power (= solar produced
energy – energy consumption at house connection) be lower than the required minimum
charging power, the car will continue charging. It will get the remaining power needed (to
fill up the balance until the required minimum charging power) from the grid.
4) Ref. Value ECO-Mode 0 Watt
Settings in this section determine how much energy is allowed to be drawn from the grid to
charge your Electric Vehicle. If value “0 Watt” is set, no additional purchasing from the grid
is allowed.
Should there be a solar battery, there could be interference in charging your car, e.g.
power supply from grid and/or power supply from solar battery. In order to avoid that,
setting the value of “500 W” is the most suitable.
5) Logmode
Off
No visualization of each charging process.
Chargings:
Tabular visualization of each charging process.
Charge-Graph:
Tabular visualization, including graphic charts of each charging
process.
Configuration instructions
eCB1
smartmeter
Version: 1.2.3
24
