Page 19 of 19
CUS
-009
-0008
-0
3
6.6 Degreaser
1. If installing double deck rotisseries, mount the degreaser shelf on the
right side of the bottom rotisserie. Hook the small lip onto the
bracket then secure with the screw as shown in
6.7 Final checklist
Please check these final three points before operating the rotisserie.
Is each rotisserie level? Use a level to verify level from front to back and side to side.
Open the front door to the 90° position and let it go, if it remains stationary then the rotisserie is
level. If the door swings closed or farther open, then additional leveling is required.
If a rotisserie is not level, the caster wheel height can be adjusted as described on page 10 for
single deck units and on page 11 for double deck units.
Is each rotisserie connected to a hot water source?
If not, please connect the water inlet to a hot water source.
Does the minimum incoming gas pressure conform to the rotisserie’s requirements?
Natural gas minimum pressure:
7” W.C. (1.74 kPa)
Propane minimum pressure: 11” W.C. (2.74 kPa)
If your rotisserie does not conform to any of the three points above, the issue must
be corrected prior to operating the equipment.
Figure 6-7: Install degreaser shelf
The degreaser shelf will come pre-installed from the factory on single
rotisseries.
