25
HARDI
MEGA 230 / 350 CENTRIFUGAL OPERATORS MANUAL
Initial installation of the shaft is done as follows:
1. Attach sprayer to tractor and set sprayer in the position with
short-
est
distance between the tractor and sprayer pump P.T.O. shafts.
2. Stop engine and remove ignition key.
3. If P.T.O. shaft must be shortened, the shaft is pulled apart. Fit the
two shaft parts at tractor and sprayer pump and measure how much
it is necesary to shorten the shaft. Mark the protection guards.
NOTE:
The shaft must always have a minimum overlap of 6"
(150 mm.)
Fig. 11
Fig. 12
4. The two parts are shortened equally. Use a saw, and file the profiles
afterwards to remove burrs.
5. Grease the profiles, and assemble male and female parts again.
min. 3/4" (20mm)
Fig. 13
min. 6" (150 mm)
min. 3/4" (20 mm)
