5 - Operation
80
Operating the TurboFiller
The TurboFiller is used to add the chemicals to be mixed with water in the main tank.
Capacity: approximately 9.25 gal. (35 liters).
Before Use
•
Push lever (A) to unlock the position of the TurboFiller.
•
Grab the handle and pull the TurboFiller towards you.
•
Lower the TurboFiller until it clicks into the locked position.
•
Unlock the latch on the left and open lid (B) fully.
•
Place chemicals for the upcoming spray job here, ready to be filled
into the TurboFiller.
After Use
•
Clean the inside of the TurboFiller with the spray wand to remove
chemical residues.
•
Place the spray wand in its storage position (C).
•
Close the lid on top of the TurboFiller and lock it on the left side.
•
Push lever (A) to unlock.
•
Grab the handle and lift the TurboFiller upwards.
•
Push the TurboFiller back in storage position, until it locks.
ATTENTION! When unlocking the TurboFiller, always keep a hand
on the handle to avoid abrupt movement of the TurboFiller!
On the next page is a short description on how to operate the valves by using the levers on the side of the TurboFiller.
For more details, see the following sections in this Instruction Book about the procedure for operating the TurboFiller while
filling chemicals.
Summary of Contents for COMMANDER 4500
