Page 3
For technical questions, please call 1-800-444-3353.
SKU 68387 & 68388
Installation
The well motor pump must be installed in a stationary
position with a fixed pipeline and a steady water supply.
Please note!
1. Do not install the pump by suspending
it unsupported from its delivery pipe.
The pump must be placed on the bottom of the shaft.
2. The pump must be installed with an automatic
float switch (not included) to prevent running dry.
Power Supply
1. The pump is equipped with a shock-proof plug
according to regulations. The pump is designed
to be connected to 120V~, 60Hz safety socket.
2. Make sure that the socket is sufficiently
secured and is in excellent condition.
3. When the plug is inserted into the socket
the pump will be on standby.
WARNING!
If the power cord or plug is damaged,
do not use the pump. The power cord or plug
may only be repaired by a certified electrician.
Areas of use
This pump is designed for use as a well pump.
Discharge
(hidden)
Intake
Pressure
Gauge
Priming
Inlet
Air Valve
(hidden)
Figure A: 68387 Components
Discharge
Intake
Pressure
Gauge
Priming
Inlet
Air Valve
(hidden)
Figure B: 68388 Components
WARNING! TO PREVENT SERIOUS INJURY
FROM ELECTRIC SHOCK:
Install indoors or in weather-proof well house only.
This Pump is non-submersible.
Do not plug in the power cord when wet
or standing on damp or wet ground.
Do not plug in the power cord until instructed to do so.
NOTE:
a. ONLY pump clean water.
b. Additional components (such as valves and pipes)
may be required for installation, but not included.
c. Installation requires skilled workmanship
and compliance with local building codes.
If you are not confident in your ability to
properly and safely install this pump, have a
qualified technician perform the installation.
d. The water to be pumped must be clean and
must be free of sand and grit, which would
damage the pump and void the warranty.
Brought to You by www.snapwhole.com
