DOWNROD STYLE FAN MOUNTING
3.
Slip downrod (A) into motor housing yoke, align holes
and re-install pin (GG) and clip (HH). Re-tighten set
screws in motor housing yoke and then tighten nuts.
Slide yoke cover (D) down until it rests on top of motor
housing (E). (Fig. 3)
2.
Insert downrod (A) through canopy (B) and
yoke cover (D). Thread wires from motor
housing (E) through downrod (A). (Fig. 2)
Fig. 2
Fig. 3
Set Screw
A
A
HH
GG
D
B
D
E
GG
HH
Hardware Used
Pin x 1
Clip x 1
1.
Remove pin (GG) and clip (HH) from
downrod (A). (Fig. 1A) Partially loosen set
screws in motor housing yoke at top of motor
housing (E). (Fig. 1B)
*Helpful Hint:
Downrod style mounting is
best suited for ceilings 8 ft. (2.44 m) high or
higher. For taller ceilings you may want to use
a longer downrod (not included) than the one
provided. Angle style mounting is best suited
for angled or vaulted ceilings. A longer
downrod is sometimes necessary to ensure
proper blade clearance.
Set
Screw
Fig. 1A
Fig. 1B
A
E
GG
HH
A
GG
HH
Hardware Used
Pin x 1
Clip x 1
8
