-S2 -18
6-3b
SEWING WITH TUBULAR FRAMES
6_3b M701
Use TAJIMA made tubular frame
You can use TAJIMA made tubular fame which has the same installation width (space be-
tween left and right positioning pin) as HAPPY's frame by changing the position of both left
and right hold springs and left and right hold spring bases.
Follow the procedure below after removing tubular frame.
1. Loosen screws (2 each at both left and right).
2. Move both left and right hold spring bases deep into screws.
3. Move both left and right hold springs forward until the spring touches screws and stops
moving.
4. Tighten screws (2 each at both left and right).
5. Install tubular frame and check if the tip of both left and right hold springs enters receiving
hole on tubular frame.
If the tip dose not enter receiving hole, loosen screw, rotate hold springs left or right so
that the tip can enter the hole, and tighten screw.
Please reverse the procedure above when returning to the position of something before
change has been made.
HAPPY
TAJIMA
Hold spring
Hold spring base
Screws
Positioning pin
1
2
3
4
5
5
Receiving hole