Two post hydraulic lift HAPP 95
© 2013 HAPP Australia Pty Ltd
Version 9
Page
29
Figure: Electrical schematic for HAPP motors.
HAPP motors are supplied with an additional connector that bridges the A2 connector as shown
below allowing a limit switch to be configured. If this connection is not required the connection is
bridged, insulated and put inside the control box. This connector must be covered with insulation
tape to provide a 2
nd
level of insulation if used or two levels of heat shrink and insulation tape
used to insulate connections. A fuse-able 4A link must be in place at contactor if not already
supplied. A third wire that earths to the connection to motor and limit switch must be fitted.
Ensure all electrical work is signed of by a qualified electrician
