Haojue VS125 99011H7H021H000 V02 EN 2021-4-7 15:11
(35)
Engine oil change
Replace the engine oil with new oil after the engine is in a
hot state to completely drain the original engine oil. Steps
for engine oil replacement.
1. Stop the engine and support it on flat ground with the
help of the main stand.
2. Remove the engine oil dipstick
1
.
3. Place a drain pan below the engine. Dismantle the
drain plug
2
and its washer to drain the original
engine oil.
4. After draining all the engine oil, install the drain plug
2
and its washer.
5. Fill 950 milliliter of new engine oil into the engine via
the oil filling port of the dipstick. Fill 1000 milliliter if the
oil filter element is replaced at the same time. Be sure
to use specified oil every time.
6. Install engine oil the dipstick again
1
.
7. Start the engine and have it run for several minutes.
8. Stop the engine and inspect the engine oil with
the dipstick several minutes later.
The engine oil
level should be between the UPPER LEVEL and the
LOWER LEVEL.
B
CAUTION
Use
the
engine
oil
recommended
in
the
“INSTRUCTIONS FOR USE OF FUEL AND ENGINE
OIL”.
B
CAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
Engine oil filter
Regularly replace the engine oil filter as instructed in the
“TABLE OF REGULAR MAINTENANCE”. The replacing
steps are as follows.
1. Drain the engine oil according to the content in
“Engine oil change”.
2. Remove the nuts
1
.
3. Remove the engine oil filter cover
2
.
4. Take the old oil filter out and replace with a new one
5
.
5. Replace the seal rings
3
and
6
.
6. Always check to make sure the spring
4
and seal ring
34
Haojue VS125 99011H7H021H000 V02 EN 2021-4-7 15:11
(35)
