Haojue VS125 99011H7H021H000 V02 EN 2021-4-7 15:11
(33)
2. Remove the screws
1
and then the helmet hooks.
3. Remove the bolts
2
, 2 respectively for front and rear.
4. First open the cover and then remove the bolt
3
,
because the middle 2 bolts
3
are enclosed by the
mounting cover.
5. Unscrew the fuel tank cap
6
and disconnect the
connection between the cable tie
5
and the fuel tank
cap
6
.
6. Slightly lift up the rear half body
4
of the storage box,
disconnect the connection between the fuel overflow
pipe
8
and the rear half body
4
of the storage box
and then remove the rear half body
4
.
7. Screw the fuel tank cap
6
to prevent foreign matters
entering into the fuel tank.
8. Remove the front half body
7
of storage box and the
saddle.
9. Remove the spark plug cap
9
.
10. Remove the spark plug with a spark plug wrench.
11. When installing the spark plug, firstly install the spark
plug and its cap
9
, and then unscrew the fuel tank
cap
6
, install the front half body
7
of storage box and
the saddle, connect the fuel overflow pipe
8
and the
rear half body
4
of storage box, install the rear half
body
4
of storage box, connect the cable tie
5
and
the fuel tank cap
6
, screw the fuel tank cap
6
and
finally install the screws
1
, bolts
2
and
3
.
Spark plug installation
B
CAUTION
A cross-threaded or over-tightened spark plug will
damage the aluminum threads of the cylinder head.
When dismantling the spark plug, keep debris from
entering the engine via the spark plug hole.
Follow the procedure below to tighten the spark plug
properly.
Carefully turn the spark plug by hand into the threads until
it is finger tight. If the spark plug is new, tighten it with a
wrench about 1/2 turn past finger tight. If you are reusing
the old spark plug, tighten it with a wrench about 1/8 turn
past finger tight.
NOTE: Insert the plug cap completely.
32
Haojue VS125 99011H7H021H000 V02 EN 2021-4-7 15:11
(33)