installation & connection
18_
installation & connection
INSTALLATION (QNV-6014R/7012R/7022R/7032R)
J
`
This camera is waterproof and in compliance with the IP66 spec, but the jack connected to the external cable is not. You are
recommended to install this product below the edge of eaves to prevent the cable from being externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
~
It must be installed on the area (ceiling or wall) that can withstand 5 times the weight of the camera
including the installation bracket.
~
Stuck-in or peeled-off cables can cause damage to the product or a fire.
~
For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
~
If the product is installed with excessive force, it may cause damage to the camera due to malfunction.
Forcing assembly using non-compliant tools may damage the product.
Disassembling
1.
Using the Torx L wrench provided, turn the 2 fastening
bolts on the dome cover counter clockwise to remove
the cover.
Installation
1.
Consider the direction to be monitored, attach the template, and
drill holes by following the template.
2.
Using 2 tapping screws, fix the camera at 2 holes drilled with a
template.
`
Set the < > mark imprinted on the camera to face the direction of camera
monitoring.
3.
Connect the camera internal terminal with the corresponding
cable.
4.
Adjust the lens in a desired direction by referring to the “
Adjusting
the monitoring direction for the camera
” section. (page 23)
Outdoor installation
When you install it outside of the building, please waterproof it with waterproof butyl rubber tape (can be
purchased in stores) so that water does not leak from the gap of the cable connected to the outside.
1.
Connect the power, I/O, AUDIO, and LAN cables.
2.
Wrap the black cable jacket (Area A) and the cable connection
area with waterproof (butyl rubber) tape so that more than half of
the butyl rubber tape is overlapped.
J
`
If the cable jacket is not waterproofed properly, then it can directly cause
leakage. Make sure to protect the cable with a dense layer of taping.
`
Waterproof butyl tape is made of butyl rubber that can be stretched to twice its normal length.
Camera
Camera
Camera
System
System
System
A
A
DC12V
3.AUDIO IN
2.ALM OUT
.ALM IN
VIDEO
1 2
3 4 5 GND
RESET
Dome cover
Camera Case
Bolts
Camera Body
DC12V
3.AUDIO IN
2.ALM OUT
.ALM IN
VIDEO
1 2 3
4 5 GND
RESET
Summary of Contents for QND-7022R
Page 40: ......