Hanwha Vision QND-7022R, User Manual

Page: 22 / 40

installation & connection
22_
installation & connection
Outdoor installation
When you install it outside of the building, please waterproof it with
waterproof butyl rubber tape (can be purchased in stores) so that
water does not leak from the gap of the cable connected to the
outside.
1.
Connect the power, I/O, AUDIO, and LAN cables.
2. Wrap the black cable jacket (Area A) and the cable connection
area with waterproof (butyl rubber) tape so that more than half of
the butyl rubber tape is overlapped.
J ` If the cable jacket is not waterproofed properly, then it can directly cause leakage. Make sure to protect the cable with a
dense layer of taping.
`
Waterproof butyl tape is made of butyl rubber that can be stretched to twice its normal length.
Attaching to the unbundled adapter
Choose and purchase a necessary one of the following options (unbundled) that is suitable to the installation
site or for your convenience.
1. Remove the dome cover from the case by referring to the “ Disassembling ” section. (page 18)
2. Use the machine screw to fix the camera case to the unbundled adapter.
3. Connect and arrange the necessary cables lest that they should be damaged or twisted while installing the
camera.
4. Install the camera body in the reverse order of “ Disassembling ”.
5. Adjust the lens in a desired direction by referring to the “ Adjusting the monitoring direction for the
camera ” section. (page 23)
6.
Close the dome cover.
` Securely fasten the fastening bolt using an Torx L wrench to prevent water from leaking.
Camera
Camera
Camera
System
System
System
A A