Hanwha Vision QND-7022R, User Manual

Page: 13 / 40

English _
13
!
OVER
VIEW
Components
1 2
3
4 5 GND
RESET
VIDEO
3.AUDIO IN
2.ALM OUT 1.
ALM IN
NETW
ORK ACT L
INK
i
h
DC12V
3.AUDIO IN
2.ALM OUT
.ALM IN VIDEO
1 2
3 4 5 GND
RESET
f
e
d
g
bc a
Item Description
a
Illumination Sensor
Detects incoming light to control the IR LED.
b
Lens Lens for the camera.
c
IR LED These infrared LED’s are controlled by the illumination sensor.
d
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J If you reset the camera, the network settings will be adjusted so that DHCP can be
enabled. If there is no DHCP server in the network, you must run the Device Manager
program to change the basic network settings such as IP address, Subnet mask,
Gateway, etc., before you can connect to the network.
e
Test monitor out port
Output port for test monitoring the video output. Use the test monitor cable to connect to a
mobile display and check the test video.
f
Audio/Alarm cable port
ARM-IN Used to connect the alarm input sensor or external day/night sensor.
ARM-OUT Used to connect the alarm output signal.
GND These are common ports to connect alarm input/output signals.
AUDIO IN Used to connect to a microphone.
g
Power Port Port for power terminal block.
h
Network Port Used to connect the PoE or Ethernet cable for network connection.
i
Micro SD Card slot
Compartment for the Micro SD card.