Single Port KVM over IP
IP-KVM Setup Tool
If this initial configuration does not meet your local requirements, use the
setup tool to change the configurations to your needs. The setup tool PSetup
can be found on the CD ROM delivered with this package. You can follow the
procedures described below.
DHCP
If you have installed the IP-KVM on a network that enables DHCP, you can use
the PSetup to find out the IP-KVM’s IP.
(1) Plug Ethernet cable to IP-KVM. IP-KVM will get an IP via DHCP.
(2) Using PSetup to look for IP-KVM.
a. Click Refresh Devices button to detect connected devices
b. Select MAC address of the IP-KVM in “Device MAC address” box. You can
find the MAC address labeled on the bottom side of xRemote. MAC address is
detected as connection from computer and IP-KVM is valid through USB or
network.
c. If wireless connection is implemented, tick “Enable Wireless
Connection...”
d. Click Query Device to find the IP configuration on the right pane.
Notes:
BOOTP, a static configuration protocol, uses a table that
maps IP addresses to physical addresses.
DHCP, an extension to BOOTP that dynamically assigns
configuration information. DHCP is backward compatible with
16 / 109
