Hanway XRAY125S 2019, Operation Manual

Page: 35 / 43

Inspection and Maintenance
32
Tire Tread Condition
Operating the motorcycle with excessively worn tires, will decrease
riding stability and can lead to loss of control. It is recommended that a tire
be replaced when the remaining depth of tire tread becomes 1.6mm or less.
Caution
The standard tires on your motorcycle are 3.50-10 4PR in front and
rear. The use of a tire other than standard may cause trouble.
Brake circuits
The front brake tank is located in the handlebar, near the throttle grip.
The Rear brake tank is located behind the rear brake pedal.
Follow the steps indicated in this procedure:
1. Keep the vehicle in vertical position with the handlebar centered.
2. The oil level lowers because of the brake pads are worn. In case
that the level is lower than the minimum, refer to the nearest Distributor to
perform a control of the brake system.
Refilling the fluid
Use only the specified brake fluid DOT 4
Follow the next operations:
1. Keep the vehicle in vertical position with the handlebar centered.
2. Remove the tank cap by loosening the securing bolts.
3. Fill up the fluid at correct level, use only the specified liquid.
4. Install the cover in the reverse order of removal.
Warning
The circuit of the brake fluid is dangerous. In case of accidental
contact, clean immediately with water the affected parts.