Hanway XRAY125S 2019, Operation Manual

Page: 34 / 43

Inspection and Maintenance
31
Engine Idle Speed Adjustment
1. Start up the engine and warm it up.
2. After engine warms up, turn the throttle stop screw in or out 50
that engine may run at 1700~1900rpm.
If you have a tachometer, you can do this adjustment by referring to
the procedures described above. The engine idle speed should be adjusted
after the engine warms up.
Throttle Cable Adjustment
1. Loosen the lock nut.
2. Adjust the cable slack by turning adjuster in or out to obtain the
correct slack of 0.5~1.0mm.
3. After adjusting the slack, tighten the lock nut.
Tires
Check the tire inflation pressure and tire treed condition. For
maximum safety and good tire life, the tire pressures should be inspected
more often.
Tire Pressure
Insufficient air pressure in the tires not only hastens tire wear but also
seriously affects the stability of the motorcycle. Under inflated tires make
smooth cornering difficult and over inflated tires decrease the amount of
tire in contact with the ground, which can lead to skids and loss of control.
Be sure that the tire pressure is within the specified limits at all times. Tire
pressure should only be adjusted when the tires are cold.
Cold inflation tire pressure
OFF ROAD ON ROAD
Front Wheel 200kPa 200kPa
Rear Wheel 225kPa 225kPa
Caution
Tire inflation pressures and the general tire conditions are extremely
important to the proper performance and safety of the motorcycle. Check
your tires frequently for both wear and inflation pressures