Hanway XRAY125S 2019, Operation Manual

Page: 30 / 43

Inspection and Maintenance
27
Engine Oil
Do the following operations:
1. Keep the vehicle in a perpendicular position to the ground.
2. Start the engine, let it idle during a few minutes and then switch it
off.
3. Wait at least five minutes to let the oil that is inside the engine to
drip down into the crankcase.
4. Loosen the tap of the refilling oil hole
Caution
Do not add different oil that is inside the engine.
5. Clean the dipstick of oil residues and introduce it again without
pressing the button. The correct oil level must be between the
reference marks “B” and “C”.
6. If necessary, refill the oil level, taking into account that it should
not go over the “C” mark.
7. Press the tap
Replace the engine oil and clean the filter element.
To assure the complete oil drainage, the engine must be at normal
temperature of operation.
Do the following operations:
1. Keep the vehicle at perpendicular position to the ground.
2. Place a container underneath the drain hole “D” to collect the
burnt oil.
3. Loosen the tap from the hole of refilling oil.
4. Loosen the oil drainage tap “D”.
5. Check that the rubber ring and the stopper ring of the drainage tap
“D” are not damaged, and then tighten the tap at the torque of
20N-m
B
C
D
A